Latest Work

Showing articles 41 - 50 (50 total)

Spirit J-42

Commission boat for transatlantic crossing Electrical: Radar & Chartplotter installation with custom pod Install Link 10 Battery monitor, High output alternator Sea Antennae, Installed SSB Mechanical: Installed Espar heating system and added fuel tank Carpentry: Separate bulkhead for anchor locker Rigging: Insulate back stay for SSB,...


Westri Able Apogee 51 Image

Westri Able Apogee 51

Fiberglass: Repaired wet core areas on deck and overhead, replace and move thru-hulls, cut away and then rebuilt cockpit sole for engine installation Carpentry: Fabricated custom teak instrument exterior dash panel Electrical: Installed ST60 speed, depth, wind, graphic display w/ repeaters below Mechanical: Engine Re-Power with100 HP...


Circe 1973 Hinckley 49

Mechanical: Constructed engine enclosure for noise and vibration Troubleshoot and repair exhaust systems Installed Espar heating system, Installed 3.2KW Mase Generator Electrical: Replaced knot meter, depth, and wind instruments Fabricated cockpit instrument plan and layout Finish Work: Spray Awlgrip on Mizzen Mast Stripped necessary teak...


A Sampling of Our Past Awlgrip Projects Image

A Sampling of Our Past Awlgrip Projects

You will be amazed by the photos of Awlgrip projects we have completed.


Crayon Pirate C&C 38 Image

Crayon Pirate C&C 38

The vessel broke loose from its mooring during a storm causing de-lamination in the sump and damage to the hull bottom. The pounding the vessel endured resulted in extensive wet core throughout much of the hull. The majority of the repair was made from the outside and keel removal was required. The repair was quite extensive and included a...


Phoenix Bristol 33

Phoenix broke loose from her mooring in a storm and fetched up on a barge. The wooden toe rail was damaged in many places. The bow stem head and furler were pulled out and destroyed. Many areas of fiberglass in the foredeck area were damaged. The steering pedestal broke and crushed the cockpit floor and also caused damage to the wheel,...


Wings C&C 36 Image

Wings C&C 36

The vessel suffered damage from grounding. The sump was delaminated and all the bilge stringers were loose. The repair required removing a large part of the cabinetry in the boat including the settee and cabin sole. All the wiring and plumbing in the bilge area was removed in addition to the water tanks. We cut out the fiberglass hull pan and...


Resolution J-34

This J-34 sustained structural damage from a grounding. The vessel suffered de-lamination around the sump area as well as structural grid work in the bilge. To complete the repair the following steps were taken: We removed the cabin sole and all the wiring and plumbing in the bilge area, and removed the engine, engine pan, and the keel. We...


Rear View

Start to Finish Wesmac 50 / Kathleen IV

The bare hull arrived at our facility in the spring of 2005 and was launched on August 5th 2008. Her maiden voyage included a presentation at the 2008 Maine Boats, Homes and Harbors Boat Show in Rockland. Many thanks to those who contributed their expertise to this project: the gracious owners for their impeccable taste in interior design, the...


New Website

Johanson Boatworks launches our new website, check it out!.


   1 | 2 | 3 | 4 | 5
Call 877-4-JOHANS or 207-596-7060

Copyright © 2017 Johanson Boatworks    All Rights Reserved    Website Design by Saco Design    Superpowered by Site Avenger    Sitemap